Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello all.i inherited a large frame-relay hub and spoke network with multiple hubs and using only static routing. there are about 10 hubs, and each remote router is connected to one of these hubs, plus a backup hub (the same for every router). we wou...
hello, thanks for your time. i've got an existing frame-relay network with about 100 endpoints and i have a project to convert the head-end host DLCI circuit from a frame-relay T1 to an ATM DS3. The DS3 is in place and I have good end to end communic...
hello. i've got a point to point OC-3 link between two cisco 7204s that i've implemented QoS over, but I need some verification that my configuration is doing what i intended it to.class-map match-all DMZ_in match anyclass-map match-all edge3000_out ...
hello all.running a 3745 with PRI card with 12.3(8)T4. We have never been able to get caller ID information on incoming ISDN calls that we use for WAN backup to remote sites. we've ordered the feature on the PRI, is there anything we have to configur...
hello all. running 7.2(2) on an ASA5510. in the Cisco documentation here:http://www.cisco.com/en/US/docs/security/asa/asa72/command/reference/c1_72.html#wp2032432it seems to indicate that you can clear the counters on all your access-lists simultaneo...
Presumeably you have networks behind that gateway router that those local hosts may need to communicate with. They may even be accessed over WAN links. In the event a link to a remote network goes down and a local host tries to access it, that gatewa...
The firewall answers the ARP request for .2 with his own MAC address because he is NAT'ing for that address. He essentially owns it as far as anything on the outside interface is concerned. So, if you were to look in the ARP cache of the router dire...
