Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i am trying to find err-disabled port on our WS-C3560G-48PS switches. I want to use the CISCO-STACK-MIB for this, object id 1.3.6.1.4.1.9.5.1.4.1.1.23. However the snmp-walk stops after portSpantreeFastStart(12).So i am never getting to 23.When i deb...
Hi,We are using a few Cisco2811's with the AIM-SSL2 hardware encryption module in a private WAN. This WAN is ethernet based and uses private address space.To add security, we are using cisco group-VPN with AES-128 encryption. The IOS version is advan...
Hi,we are starting to replace low budget hubs by the SG-300's. On the accessports we use BPDUguard and mac security (max 1 user per port). The newest firmware is used (1.1.2.0). When i lock a port intentionally by connecting e.g. ports 4 and 5 togeth...
Hello I see from a previous post that mid 2009 IPv6 OSPF routing within an VRF context is not supported. Does anyone know if this is still the case?I'm running C6506-E VSS 12.2(17r)SX5.thx
Hello,Does anyone know if ACE service module support SHA2(256) certificates? I see that private key generation defaults to SHA1 and does not provide any option, also the cipher suites in SSL parameters map do not show SHA2 options. Can it handle SHA2...
@Peter:thanks for your support on this one. We did start a case at our supplier which then will relay it to the TAC team if they cannot find out what it is themselves. As far as i understood they did log a TAC case and Cisco's reply was : ' as soon ...
Hi Peter,output of show crypto gdoi GROUP INFORMATION Group Name : getvpn Group Identity : 1234 Rekeys received : 101 IPSec SA Direction : Both Active Group Server : 192.168.0.2 Group Serv...
Hi Randy,thanks for your reply. Now we at least can see the violation -and- lift it in the same interface (CLI).Do you by any chance also know if the webGUI has a place *where* you can see the port is blocked ?
Hi Peter,passwords and some ip addresses have been anonymized, but this is the whole config.version 12.4no service padservice timestamps debug datetime msec localtime show-timezoneservice timestamps log datetime msec localtime show-timezoneservice pa...
Hi Peter,"Has the same phenomenon with high CPU been observed on other routers in your VPN?"Yes, all routers in the WAN (and in the same groupVPN) show exact the same behaviour.
