Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Could you please assist, I preparing to setup ACS 5.0 and integrate it with an external AD database. Would i need to make any configurations on the AD servers itself, and what settings do i need, if any?PM.
I have set up a TACACS+ server on our network for user authentication, autorization and accounting. I have one hitch though, i need to find a way of authenticating the reverse telnet sessions that use the command: autocommand telnet hostname /streamI...
We recently upgraded our Data Center, installing new Catalyst4507 switches. The problem is on one of the connections from the Cisco 3745 router connecting us to the WAN. If i connect the router fast ethernet interface to the cat 4507 switch the conne...
We recently upgraded our Data Center, installing new Catalyst4507 switches. The problem is on one of the connections from the Cisco 3745 router connecting us to the WAN. If i connect the router fast ethernet interface to the cat 4507 switch the conne...
Has any one in this forum encountered the following error message when trying to use the Active Directory for user authentication with Cisco 1120 ACS 5.0?:"Error while configuring Active Directory: Using writable domain controller: company.com: (Kerb...
How would i then enter the username and password as prompted by the TACACS+ server. As illustrated above, i am using the autocommand telnet hostname 4065 /stream command to establish a reverse telnet connection through an async interface. And there i...
The interface configs i have are as follows:ROUTER------Int FastEthernet 0/0 ip add 10.0.0.1 255.255.255.0 speed 100 duplex full no shutSWITCH------Int FastEthernet 3/3 switchport mode access speed 100 duplex full no ip addBasically this is a...
