Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone else had this problem? Just completed inline upgrade from 2.2 to 3.0 and our scheduled jobs appear but there is no config data listed under them and they fail. In the jobs dashboard. I'm going to open a TAC case but I didn't see anyone ...
I'm running into this message when attempting to restore a 3.2 backup into 4.2.3C:\Program Files (x86)\CSCOpx\bin>C:\PROGRA~2\CSCOpx\bin\perl C:\PROGRA~2\CSCOpx\bin\restorebackup.pl -d c:\backup -gen 0*************************************************...
At the command prompt when I attempt to stop the daemons with net stop crmdmgtd, the system returns this error message:System error 5 has occured.Access is denied.My account is an admin account so I'm puzzled by what may be causing this.Any ideas? ...
Has anyone run into this issue where the job scheduler in CPI 1.2 report that the job that is being scheduled is before the current time even though it isn't ?This only started happening after our time change yesterday. The system is setup for the c...
We have a master / slave cw2000 lms setup with devices showing up on the slave but I'd also like to see the netconfig jobs from the master on the slave system. Is there a way to import them to the slave system?
Thanks so much! After I posted this I went back through the Health Policy and did exactly this after finding the interface monitoring status box. What I ended up doing was changing the policy and then applying it only to the secondary system; it to...
I'm also getting this message but it's only on our secondary unit in an active / passive failover scenario. I've configured the policy and redirect on the primary and it appears this is copied to the secondary system but I'm getting this message on ...
Redundancy Failure Event trap triggered by Controller for the reason 'Error: Config Sync failed on Standby for the usmdb:HA_send_usmDbMsAddToBlackList,' ; this is in 7.6.130 which we just upgrade to this morning but we also saw this in 7.6.110. Any...
Thanks so much! I did continue to research this from the 2.2 migration section and found that the name of the application backup is NCS; this was the key. Thanks for your quick reply and as always ... you make this forum what is .... a very valua...
Hi Marvin, Did you do an appliance backup or application backup? I was hoping to simply backup our existing data from our 2.1 server then restore it to the new 2.2 CPI server (VM) that is up but then in the course of doing this I noticed there are t...
