Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Community, I'm trying to add my newly installed FMC Virtual (VMWare) to our monitoring system (LibreNMS) with no luck. I have followed this guide and tried with both SNMP v3 and SNMP v2C. The access list has been configured, tried with both a spe...
Hi WiFi experts,
I'm looking into Fastlane and have found it a bit limited with its fixed setting of AUTOQOS-AVC-PROFILE AVC profile. I would really find it beneficial to be able to adjust the AVC profile after my needs. Does any one have a clue of ...
Hi Experts,
I have an interesting problem that makes all of my "Fix jobs" to fail. In short - I make configurations blocks of switchports and then run a number of "match expression" within that block. In case of a violation I have specified "Fix CLI...
Hi Experts,
I'm trying to tune our Storm-Control settings on host ports and have problems to determine if it's broadcast or multicast levels that's need to be adjusted.
When the upper level has been exceeded, a syslog is generated but it does not in...
Hi Experts, I'm trying to figure out what the "new" option behind software install is all about.The Command Reference doesn't help me much:"(optional) Indicates that the post-install package set should contain only the packages being installed. Witho...
Great video, thanks! But I miss the big picture here - Is this pxGrid Direct integration with ServiceNow CMDB just for adding additional data to the ISE custom attributes for existing endpoints? Or is it a way to fetch the complete identity, icluding...
I find it very intressting that the problem description says " non service impacting". Well, it is. You have three choices and all of them are certainly "service impacting":
1: Do nothing and wait for the crash.
2: Periodic reload
3: Change release
...
One thing worth mentioning is that "Total output drops" is reflected to "output errors" in IOS-XE for Cat3k, which was not the case in traditional IOS-based switches.So it might not be "output errors", just an overutilized interface.
This output is ...
Hi,
Yes, as joshelton wrote below. It does resolve the issue. But the workaround has a drawback. Every fix means a seperate Fix job, even if the Fix CLI should be sent to the same switch. For my use case, checking Port-Security parameters on host po...
Why would you have DHCP Snooping in the Core at all?
I run DHCP Snooping at a couple of hundred switches with no major issues, but I do see some minor problems mostly because bad client behaviour. MAC address validation is one example, some client w...
