Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Due to a merger I need to migrate users on a CUCM 7.1.5 cluster to a new cluster on 8.6.2. Any tips, pitfalls, caveats, or gotcha's I should worry about?
I have 3 ws-c3750-48ps in a stack and i'd like to enable dot1x on the stack I entered the commands:dot1x system-auth-controlaaa authorization network default group radiusaaa authentication dot1x default group radiusI also have dot1x enabled on severa...
I'm new to ACS 5.4 and have very limited knowledge of the previous versions. I am trying to get users in the external identity store (AD) to be dropped directly into enable mode after being authenticated, since I don't know of a way to set an enable ...
I have intercom setup, configured and working in CUCM 8.6. - Here is the scenario -- a secretary needs to reach her boss that is in a meeting in his office, they have an intercom setup between they're phone but the boss doesn't want the secretary to ...
I have acs 4.2 for windows installed on a windows server 2003 box, because of a merger I need to now authenticate against 2 different domains, there is a bidirectional trust between the two domains and the dial-in permission has been set in ADUC but ...
Richard,This is the optput from the show ver from the stack at the end is the output from the show switch commandcisco WS-C3750-48P (PowerPC405) processor (revision E0) with 131072K bytes of memory.Processor board ID CAT0906R08ULast reset from bus er...
Jatin,here's the config from 3 different interfaces one from each switch in the stackinterface FastEthernet1/0/6 switchport access vlan 25 switchport voice vlan 125 speed 100 duplex full srr-queue bandwidth share 1 25 70 5 srr-queue bandwidth shape 3...
To all those eagerly awaiting the answer to this question:This step by step guide assumes that you are using an external identity store or not requiring your internal users to have a separate enable password, and that these have already been configur...
