Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
FPR1010 Is there any way to modify the system via cli like the ASA? I know you can get into the system support diagnostic-cli but that doesn't allow for much. Is there another way to config through cli?
I have a Cisco ASA 5525 and we are have users connecting with AnyConnect. I can look at the ASDM and get the current active users sessions. I am looking to send that info to syslog but I am not sure what my config should look like. I am looking a ...
I purchased a new ssl cert for my Cisco ASA 5506. I installed it and there was an exterior scan run against it. The scan failed. Here is the error:SSL certificate is untrusted How do I resolve these error?Any help is appreciated.
We currently have AnyConnect configured and it's working fine. I need to add a new VPN connection for users and I need to force all traffic for this connection to go through the tunnel for security. I need to make sure I don't break the existing se...
Rob,Thanks for the response. That was the answer I needed. I did however try to upgrade to the version you recommended and my system won't upgrade. I goes through the process and looks like it is but then about 30-45 minutes later it is the origin...
Marvin,Thanks for the reply. As I am new to SNMP settings. What would thecommands be for doing an SNMP query or for that matter how would you grabit with events?Thanks,Ken
The certificate is based on the FQDN as you said but they are scanning the external IP address. Also, the cert is applied on outside and inside interfaces.
I have done as you suggested and the VPN traffic going to my internal networks is working well, but the internet bound traffic is not working now. Meaning when someone connects to the VPN they can't get to the internet. I think I am missing somethi...
