FPR1010 Can you change the port for webvpn like you can on 5506

[KEN COUSINO JR.]

FPR1010 Can you change the port for webvpn like you can on 5506 so it doesn't conflict with remote management?

[Rob Ingram · Accepted solution]

@KEN COUSINO JR. I assume you are running the FTD image on the FPR1010 device? With local management using FDM?

You can create a custom port from version FTD 6.7 to avoid conflict with remote access VPN service port.

https://www.cisco.com/c/en/us/td/docs/security/firepower/roadmap/fdm-new-features/firepower-device-manager-new-features-by-release.html

[KEN COUSINO JR.]

Rob,

Thanks for the response.  That was the answer I needed.  I did however try to upgrade to the version you recommended and my system won't upgrade.  I goes through the process and looks like it is but then about 30-45 minutes later it is the original version.  When I do the upgrade there is a check box to revert to the original is there are problems and I have that checked so I am not sure what is going on.

Thanks,

Ken