Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I had configured this ACL through Flex Config
access-list CPLANE extended deny ip host 185.11.61.172 any access-list CPLANE extended permit ip any any access-group CPLANE in interface outside control-plane
I want to add new IP to block. But when I di...
I have virtual FMC and two FTD 2120 boxes. Version is 7.0.5.
I want to see Interface statistics in Health Monitoring. But there is a statement "Throughput module is disabled in the health policy". I was looking in health policy for this two FTD, but ...
I use firepower v.5.4.1 on ASA 5516. I see huge amout of malware comming via mail (smtp connection). Almost every malware detection is only retrospective. It means malware reached customer mail servers and maybe users mail-boxes too. IP addresses of ...
I am using WSA in transparent mode, ASA as WCCP redirector. I can not get some pages. (www.arspoetica.sk for instance) Browser (Mozila) open file save dialog with application/octet-stream application. But there is no such a stream from this page. Whe...
WSA on the System Capacity page shows graph of Rasponse Time / Latency.What does it mean? Is it WSA latency? When I see (for example) 500ms latency, does it mean, that WSA was busy and showed web page to user with 500ms delay? What or who is late, wh...
I have enabled interface status monitoring. I do not have problem with false alarms. But with not seeing (interface) traffic statistics in Health Monitor.
As I wrote in my opening post, I use this buit-in feed. But these are poor. Because I receive tens of malware file per day. From IP addresses, which are known to Cisco (senderbase.org) as malware senders, but not included in built-in feeds. I am look...
