Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Team,
We setuped a model as attached file as:
PC1 ( Hyperterminal), ASYNC ==> RS232 ==> (Serial 0/1/0/ Router 1) ==> IP ( Router 2, Serial0/1/0) ==> PC2( Hyperterminal), ASYNC.
Detail configuration in attached too. After configured i show inter...
Dear all,We use Call Manager 10, and IP Phone 7962, IP Communicator. But when IP Phone call IP Phone, IP Phone call IP Communcator and vice versa, IP Phone still ringing forever.I set up no answer duration 10s but it still no luck.But is setup no ans...
Dear all,We setup Cisco Call Manager 10 with Cisco Voice gateway 2911 ( E1 port) and 3905. All outgoing call & incoming call are ok. But we meet a small issue as below:-Using 3905 do outgoing call to mobile number. Mobile number ringing.-3905 failed ...
Dear acampbell,
Cable from the router is DTE Male to Smart Serial (cable 1) as below:
Connector 1: Smart Serial 26-PIN Male Connector 2: DB25 RS232 DTE Male
You can see detail in attached file. Please review again ! Thank you !so much
Regards,
ThanhN...
Dear acampbell,
Our PC set to 9600 default.
Our Router use the 1st cable as
CAB-SS-232MTRS-232 Cable, DTE Male to Smart Serial, 10 Feet
Then connect to (Com RS232) 2nd cable to PC
So any advise on this case. Please help me. Thank you !
Regards,
T...
Dear George, I just want the phone to go hangup after ringing for 10s.I tried setup on Cisco Call Manager parameterForward No Answer Timeout but still no luck. Dont know why, very strange.Regards, ThanhNT
