Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to specify a backup peer IP address on a Cisco ASA v8.4 when connection to a SonicWall firewall via a site-to-site VPN? The "crypto map set connection-type" seems to be specific to VPNs between Cisco devices.Does anyone have peer fail...
Since upgrading to AnyConnect 3.0 the AnyConnect client automatically starts everytime I boot my Windows 7 PC and login to my Windows profile. Disabling start before login in the client didn't fix the issue. I know I can remove AnyConnect from the ...
I have a 3560E switch and we are seeing spikes of high CPU utilization for the "hulc running con" process. My understanding of this process is that it is used to copy the switch configuration from the master to the slaves in a stack configuration. ...
Is it possible to stop multicast traffic from flooding all switch ports on a VLAN without a router interface on it? IGMP snooping only seems to work if there is a router interface present on the network with PIM enabled. I believe I can statically ...
What is the best way to filter multicast groups on a router between a provider's network and ours? We are using AutoRP between the networks.I have a set of multicast groups that I would like to permit and filter the rest. I tried using an access-gr...
This doesn't seem to work when the site-to-site VPN is between a Cisco and a non-Cisco device. Does anyone have failover working with a Cisco peer on one side of the connection and a non-Cisco device (Sonicwall in my case) on the other?Thanks.V/
Unfortunately, this isn't feasable when deploying the client to hundreds of PCs. There needs to be a configuration option in the client to stop it from starting upon boot. Not sure why Cisco changed this functionality in the AnyConnect 3.0 client, ...
I am using a 4948 switch running IOS v12.2(31)SGA. The "ip igmp snooping querier" command doesn't seem to be available on the switch.What other options do I have?V/
I am using sparse-dense mode with auto RP. I was under the impression that I had to use sparse-dense mode.Using the "ip multicast boundary" command I seem to be able to filter the groups on the connection between my router and the providers. Unfort...
