Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We recently had the Aironet 3502i APs installed in our infrastructure and are having a bad time with hosts connecting to them. The controller sees them, they have an IP, they are showing a solid green light, but you cannot get devices to connect. If ...
So I have an old VPN 3000 Concentrator that I do not have any idea what is running on it. The previous network admin didn't leave a password for it, so I tried to reset the password. I was successful in doing so, but when I try to access it with the ...
So I was given the task to set up a new VPN tunnel for a client and even though I've basically made it open, we still cannot ping each other's endpoints. I troubleshooted for over an hour with one of their techs, still to no avail. I included the con...
Hey all, kinda new to this whole network management thing, but I've been trying to determine why there is a huge discrepenacy in network speed for users on the same switch. I can get about 30mbps while my boss can only get 6 mbps. We are both locate...
Gained access by admin/admin, but the console is still showing all the VPN tunnel traffic. I can't do anything because the tunnel is killing any results that are showing up. I don't know how to turn it off because I can't see any screen to turn it of...
Menu based command line? Like the one in the GUI? I cannot access the GUI whatsoever. And like I stated previously, the only output I get from the console connection is the running VPN connections.
Rizwan, Thanks for your help. It seems a setting was not set properly on the tunnels (FPS) and that what was causing the issue. I also started from scratch and rebuilt them. The tunnels are up and working now. Thanks again for your help.
