Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
GreetingsWe've been setting up our switches with a central logging server and on a 2960x we get both a failure and success syslog message for each successful login over ssh: Syslog logging: enabled (0 messages dropped, 1 messages rate-limited, 0 flus...
Hi!
We have just replaced a Cisco 2960S iOS version 12.2 switch with a 2960-X iOS version 15.0 48-port switch. Apparently there are some differences, because we configured the new switch just like the old one and are having a problem. This switch ...
We've been banging our heads against the wall for the last couple days trying to solve the issue with our Zebra scanners and roaming between APs. Support advised us to disable Mandatory DHCP and it worked, the first thing we said after that is that t...
I just found this thread after experiencing the exact same issue with Zebra scanners and our brand new Meraki APs. Meraki support advised us to disable Mandatory DHCP and it fixed the issue right away. We're on MR30.6 firmware, so I can report that i...
Hi BB. Thanks for responding!I was just wondering why the switch logs a failed attempt for every successful login. When I login to the switch, it logs a failed attempt then logs the successful attempt 2 seconds later. Why would it log a failure if th...
Aha, and more mystery today. I got to work early so I could try to troubleshoot those computers in the office to make sure they could do their work today. When I went in there, those computers are accessing our network, the internet and the phones ar...
Thanks for the help. That switch is connected to an Aruba s-1500 12 port switch in the small office. Nothing has changed on that end, but it comes into a trunk port on native vlan 1088. Here are the results of those commands:
PioneerSt-2960-X#sh...
