Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all As per post title, a couple of questions: 1) Will MACSec encryption work between the above switches (using 1Gig port on the 3850 and a 1Gig SFP on the 4500-X)?2) If so, what versions of software are required, and what is the minimum feature se...
Hi allWe purchased 2xASA5512X, IPS about 1 year ago, and have been deriving limited benefit from the IPS.Is it possible to change from IPS to CX without throwing out the firewalls? AVC/WSE will be more useful to us at this stage. So if we buy the 120...
Hi everyoneHoping someone can clear this up for me, as it's working but I have no idea why.we have a nat exemption rule for 10.0.0.0/8 to w.x.y.zfollowed by some static nat rulesand thendynamic policy nat rule for 10.0.0.0/8 to w.x.y.z natting to IP ...
Hi everyoneI need some advice on a switch which can provide the following:1) ipv4 and ipv6 L3 routing in hardware (+HSRP)2) 10G connectivity to servers (~5 metres away)3) 10G connectivity to other switches (~1 metre away)3) 2x1G connectivity to other...
Hi allWe have a rather strange issue, and I'm not sure it's really a problem with the ACE or not, but perhaps someone can help out.We created an HTTP parameter map called "TCPreuse" and applied it to a virtual server. A show conn detail displays "[ c...
Thanks, that is very helpful. I see later versions (8.3+) allow reordering of these rules. We will be upgrading sometime in the not-too-distant future and then we will have this functionality. Right now, the config is working so I won't risk deleting...
You are correct, it isn't actually getting natted. I did a packet capture on an intermediate device after the firewall, and saw the non-natted address.This is only working due to some funky routing we have between the load balancers and web farm, and...
One more question - connecting two 4900M or two 3560E switches together - is it as simple as using a 10GBASE-CU SFP+ cable between two OneX modules? I.e. no cross-over cable required?
