Hi,
We have a 10.5 CUCM cluster with a Pub and a Sub. We also have hardware conferences resources in a 2811 ISR.
Conferences resources are registered to Subscriber, but when we make a conference with external numbers, the remote IP address shown ...
Hi,I need to set up the parameter Web Access to enable when I add a new phone in my CUCM.I have checked that for phone type 3905 this parameter is set to enable but for phone type 7911 is set to disable.Anybody know if we can set the parameter to ena...
Hi,I´m trying to regenerate a certificate for Cisco 7911 in a CUCM secure cluster, but after a few minutes the status is:Certificate Operation Status: Operation Pending Note: Security Profile Contains Addition CAPF Settings. This phone has ...
Hi,We are going to migrate our CUCM custer from version 6.1.2 to 9.1Now we have MCS servers and the new cluster is going to be in virtualized UCS.We have removed one of the subscribers of the cluster to upgrade this server until version 8.6 (we need ...
Hello,We need to know the firmware version used for each one of the devices in a CUCM cluster (version 6.1)Anybody know if we can get this info for example wit the BAT?Thanks and regards,
Hi Ayodeji,
Thanks for your answer.
I´ve create an MTP resource in the gateway and I´ve include it in the MRG of the phone which makes the conference, but I´m still seeing that the remote address for the externals in the conference is the IP add...
Hi Steven,
Ok, I´ll check it with service provider.
The routing issues are because our SIP Trunk is routed throught 2 CPEs, each one on one of our main sites:
Publisher is on site A and Subscriber is on side B.
If call is made for a phone in ...
1. I assume the call manager service is activated and running on the Publisher?
Yes, it´s activated and running
2. the gateway that terminates the SIP trunk, is there a dial peer that points to the Publisher? is it the preferred dial peer?
We h...