Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure what should be a very simple setup. Two 9800-Ls on a bench with a switch in between. They can ping each other when I configure SSO on both boxes, and I can ping the secondary. But neither will ever become the standby.I'm w...
This is a lab box, on a bench with a flat 192.168.1.x network and g0 is connected. Not connected to the Internet. Can ping g0 from local subnet. When we try to browse to it, we get "The connection for this site is not secure". This actually worke...
We have a dozen or so ACLs in our AirOS controllers, and I'm making new configs for the 9800 refresh. I am using the conversion tool as a starting point. Meaning, I am not using the conversion tool and taking the output and blindly copying it into ...
Can Cisco Prime run an inventory of WLC Interfaces and WLANs? This may seem like a simple task when looking at a single WLC, but I want an inventory of 100+ controllers with what each WLC has for Interfaces/IP addresses and what WLANs are configured...
Is there a way to migrate from legacy Cisco 1131s to 3802 or 2802 series access points. As I understand it, the 1131s can go up to 8.0 code, and the 2800/3800 start at 8.2 - which leaves no migration path except standing up another WLC with the code...
This worked on a pair of SSO lab 9800-l-C controllers. I still have one weird issue though, and I cannot determine if its related to the trustpoints. This is on the bench - 192.168.1.x. Controller is up, operational, and my new win11 box can brows...
I just did. Backup is now DEFINITELY on 17.9.04a The Primary is also on same code. Again, when I connect both to the switch, the Primary changes to edh001-001-wc01(recovery-mode)>Both are in INSTALL mode.Both are 9800-L, however one has SFP por...
I think I found the issue. I erased the config and started over. Same exact issue. As I was rebooting, I saw this message on the console. I just happened to see if as it was scrolling past."Details: Chassis 2 is detected INCOMPATIBLE with softwar...
I think I found the issue. I erased the config and started over. Same exact issue. As I was rebooting, I saw this message on the console. I just happened to see if as it was scrolling past."Details: Chassis 2 is detected INCOMPATIBLE with softwar...
