Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, Have an issue where we are trying to access a vmware view 5 desktop outside our network.The view desktop system is owned by another company and is accessible from the internet. From our network behind asa, our client to the view ser...
Hi, looking for guidance on connecting a 5548 pair to our core 6509s. Just want to be sure we don't introduce any issues into the network.The 6509's are connected and perform all the routing. Essentially, we're moving away from a 3750 stack in the ...
Wondering if anyone else has had this issue.Situation is that units are trading active status between devices. Was fine until about a week ago. Performance has been sluggish and asdm is slow to load, sometimes dropping connection. We have multiple ...
Hi, I have successfully connected to a remote site using client from behind our asa, however we are unable to access any resouces over the tunnel. If we use same laptop, same config on an un firewalled cable modem connection, we are able to connect ...
I have a pix 515 6.3. Currently have client vpns etc. with no problems. I would like to use my eth4 interface and a separate subnet for vpn clients to hand off to an internal router. I specified a access list with nat (eth4) 0 access-list for this...
Hi All,Just wanted to close this out and let you all know what to do if you run into this scenario.Once the 5548's are configured properly, create 2 port channels. In our case we created two (4x1gb) port channels. Each port channel consisted of 2 ...
Have you verified the comport / cable works with another router, as someone suggested? If that has been verified as working, are any of the pins on the console port bent or have they moved or slid over or missing so that the connection can't be made...
Assuming your firewall is adequate and has at least 1 LAN port, turn off the wireless if you don't plan on needing or using it, then purchase a small used Cisco 2950 12 port model on eBay and connect it to your firewall LAN port using a crossover cab...
Using the 5505 might not be adequate. May want to go for more horsepower for that many users. Depending on how your cabling is, and number of data closets, you could use a 3560 or 3750 and a couple 2960s. That would give you the layer3 and vlans you...
You might be on to something with the server trunk. If if is on gig1 and that is configured as a trunk that would explain it all. Routing could be working just fine but if the server is where they are trying to ping from it makes sense why it isn't w...
