Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have a little issue with our Prime Infrastructure 3.2 installation.
We have installed a standard virtual instance on a Vmware Esxi 6.0 installation.
We have created some virtual domains, and our problems is that when a administrator want...
Topology:Client <---> L2 <---> L3 <---> R1 <--- GRE ---> R2 <---> L3 <---> L2 <---> ClientThe L3 is used as gateway on each VLAN, and is therefor doing intervlan routing.VLAN topology on left side:VLAN 10 - Client - 10.10.1.xVLAN 20 - Server - 10.20....
Hello,I got a bit of a problem, with my asa config.The asa is configured to allow anyconnect, with local users.but after i added the following NAT statement and ACL on outside, i cant connect with Anyconnect.nat (DMZ,OUTSIDE) source static HOST_DMZ-N...
Hello,As of today, i have experinced a problem with my ACS.After a reload my ACS is stuck, and have been stuck there for more than 3 hours, at the boost screen.The last line that it as writen is:INIT: Version 2.85 booting..If i do a hard reboot of th...
Hello,Im trying to get my asa to route between 7 vlan's (later on i will restric access to some of them with access-lists), but i have a few problems with it.My setup is ASA5510 - 4503e - 3750 - IBM BladecenterThe clients (VLAN10) will be connectet ...
Sadly i aint allowed to share full config, or part of it.did the packet-tracer command:Result of the command: "packet-tracer input OUTSIDE tcp 1.1.1.1 12345 21"Phase: 1Type: ROUTE-LOOKUPSubtype: inputResult: ALLOWConfig:Additional Information:in 0...
Hi JouniFross,It didnt help, other than now the VPN is working, but now there aint any FTP access.just to clarify what i need to get working.VPN (Anyconnect) so my travling users can connect when they have a need for it.FTP Access (DMZ) so the server...
Hi Jatin,Thanks for the reply,Im guess that the system has totaly crassed on me, as now when i go in to runlevel 3, it sais:(none) login:and after login:(none)/admin#nf:Read-only file system/etc/lLogrotate.d/ADE: Read-only file systemDispite that, i ...
