Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a limited understanding of vlans and wanted some clairification on a config I'm trying to set up.As an added bonus, I wanted to ask about redundant wan connections.Our datacenter provider is providing us with 10 Mbps Base Commit delivered on r...
I wanted to verify something I believe cisco at one point told me about routing from inside to the outside interface.My firewall is assigned the network for the outside interaface. 206.168.224.1/28. The inside interface is assigned 192.168.1.1/24. Th...
As an admin, I sit on network 10.40.45.0/24.I tunnel to our datacenter like this10.40.45.0/24 -- tunnel to asa @ datacenter 192.168.199.3 -- 192.168.199.0/24 -- datacenter gateway (pix) 192.168.199.1 -- DMZ 192.168.200.0/24What routes would I have to...
I'm trying to communicate on port 53 (doman/DNS) from my DMZ to the inside interface. I's just not working. I've even been on the phone with cisco and he can't get it to work.Right now I'm trying to verify two things.1. When i do a packet trace, it s...
I'm putting a couple of servers in my DMZ on a PIX 515E. The inside is nated (192.168.199.0/24) and the DMZ is nated also (192.168.200.0/24). inside the DMZ is an ISA 2006 server. I was to block that server off entirely except from the inside network...
I guess I was using a ping for an example. The real problem is I have a monitoring and ticketing system that use sendmail to relay email messages. They sit on the NAT LAN on the inside interface. So when machine 192.168.1.100 on the LAN tries to send...
OK,Then is the gaddr 192.168.200.107/0 an address that gets dynamically created when the tunnel is created? I dont have any machines on the network with that address, and I am initiating a connection from the inside interface from machine 192.168.199...
Most of the documentation I've been reading has suggested that PIX515E ==dmz== Edge server == ASA 5505 == LANseemsto be the best practices setup config for exchange with an edge server.http://www.netometer.com/blog/?p=70http://msmvps.com/blogs/ehlo/a...
Brent,Well, my problem is that I do have interesting traffic flowing from the 46 network to the 45. But if the tunnel goes down or the router gets rebooted, no amount of traffic from 46 to 45 brings the tunnel up untill I log into the asa on 46 and p...
