Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have created a very simple dial-peer config shown belowdial-peer voice 200 voip destination-pattern 8.T session target ras dtmf-relay h245-alphanumericHere is the problem, I used a Cisco 7960 IP Phone to make a call to my destination 8123, th...
Hi Forum,Just to find out a little more detail in regards to the guest account created for web authentication using Ambassador account.1) If the authenticated guest did not perform a proper logout, what action will the WLC take?2) As such, is there a...
Hi Guys,i am facing an issue where my Appls is receiving more post request then what had been sent by the client.It was reported that Appls log 3 http post but client only submitted one request.To troubleshoot, does the CSS has the ablility to view H...
Hi Guys,I dont seems to see CPU Utilization Details & Memory Utilization Details in Device Center nor HUM for ASA.Is it not supported or likely config issue?CiscoWorks Common Services 3.1.1Campus Manager 5.0.3CiscoView 6.1.7 CiscoWorks Assistant 1.0....
Hi,I have already put the following firewall rulesAny to CUCM network and IP Phone NEtwork permitCUCM network and IP Phone network to Any permitSo I dont know what else is causing this.Damian
The following is a SNMP walk of device 10.60.95.254 starting from .1.3.6.1.4.1.9.9.109.1.1.1SNMP Walk Output--------------------------------------------------------------------------------.1.3.6.1.4.1.9.9.109.1.1.1Hi Clarke,Thanks for your response. ...
I got this results. Anything else i should be looking at?The following is a SNMP walk of device 10.60.95.254 starting from .1.3.6.1.4.1.9.9.109.1.1.1.1.8 SNMP Walk Output--------------------------------------------------------------------------------...
My poller are using the Cisco default template. No new templates are created.i noticed the following status errors.cpmCPUTotal5minRev ASA 5510 Adaptive Security Appliance Transient 1 Request Timed-Out. Device may be down. 04 Aug 2008, 20:47...
