Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have 2 Routers (2911), 2 ISP Connection, 1 /24 IP Block and AS Number. Indivitually, I did the BGP estbilishment with ISP. Now I trying achieve the load balancing as show in the above figure. 1. Is it possible to split the /24 IP Block into 2 ...
I am trying to config the following setup in the Cisco 1841. Able to ping the IPs of Vlan1(FE0/0/1), Vlan2 (FE0/0/1) and FE0/1 IPs from crossponding networks. But packets are not flowing to other side. Any clue?
Thanks AG. ISP told us, they won't route any thing above /24. Does it mean I cannot do the load balance? Any other trick?For redentency, I will go with HSRP.I don't understand your tips about routing table entry reduction. Can you give some info?But ...
Sorry for the late reply. Unfortunatily I don't have the config file me and router is taken over by other team. I will get it after 2 or 3 weeks. I will come back with updated config file.NAT Overload was not there,Will it cause the problem?Thanks
