Can you add Access Rules to A VTI interface in ASA 9.8?
I see the tunnel interface showing as up in the ASDM, and I can ping the end points from the CLI, but when I chose "Add access rule" in the ASDM the list of interfaces does not includ...
I have a ASA device with a management interface with IP address 192.168.1.1/24
and also on this interface are switches that also have ipaddress on the 192.168.1.x range.
The rules on the firewall say that any traffic comming in to firewall on...
can any one tell me exactly what running the "remote-span" command under a vlan does? I know you use it for source and destination span sessions, but what changes to the vlan does this command actually achive?
The reason I ask is that I want ...
Hi, I have 2 X cisco routers running BGP multihomed to our ISP, these two routers connect back in to our firewall (checkpoint) that is in a HA balanced pair. and for simplicities sake lets image I have 2 subnets that I advertise to the ISP A and B. ...
Hi, As you can see below I see a mac address picked up on VLAN 1 on this switch, however vlan 1 interface is shut down? This is causing connectivity issues so does any one know why it is happening? Cheers DP1-West#sh arp Protocol Address ...
I did add an ACL to the interface via the CLI, but I still can't add rules to the ACL via the access rule GUI interface? I assume this is a limitation of VTI interfaces.
Seems the ASDM does not recognize VTI interfaces in this way
I not sure it is, as syslog is explicitly set to send with a source of "management" not outside.
However using the packet trace function in the ASA and putting
192.168.1.1 as the source the packet shows as blocked
setting it as 192.168.1.10 and...
I will have to check but as far as I am aware it is set up like this
Outside interface = 126.96.36.199
management interface is 192.168.1.1
VPN is between the outside interface and the remote ASA device.
syslogs messages soure interface is set as ma...
but this seems to suggest rsan can run STP,
but when i enable it and then try to trunk it to a Nexus switch I get this error, I know the nexus does not support the "remote-span" command on a vlan but I am only trying to run this as a trans...