Hi Team In a company where IOS is developed and tested they use to have all the network equipments in individual hardwares such as routers, switches, traffic generators,servers etc.. Hence instead of going for hardware is it feasible to implement NFV for R&D team where our networ functions are virtualized. So will it give all the functionalities as we get it from hardware and with NFV we lack behind the functionalities. How will be the implmentation cost defers with NFV when comparte to hardwares. It will ease the networ kset up as its virtualized definitely. Please suggest the views and comments. Regards Naveen ... View more

Hi team, I work in a organization where we have ten thousands of VOIP phones which draws inline current via LAN port. Which in turn draws current by POE port of network switch. in non office hours if we switch off the network switch which is dedicated only for VOIP phones (We have diffrent LAN port for voice and data), is it a good idea and feasible,efficinet to schedule powering off network switch daily. In general what is the average power consumtion of individual IP phone per hour/day ? Will it be a good idea to follow this process. Please suggest your views for the same. Regards, Naveen ... View more

Hi Team, Whenever we configure the OSPF area as stub, it allows only TYPE1,2and 3 LSA and in Totaly STUBBY only Type1 and 2 LSA's are allowed. In that case ABR will be advertising the default route within the stub area. So My question is 1) Will default route is created by ABR automatically to help stubarea to communicate to Area 0 or it should be created manually. 2) The default route belongs to which type of LSA and STUB area does'nt allow all types of LSA's Please clarify . thanks Naveen ... View more

Hi Team Am could not able to view the past discussions raised by me in support forum. Please assist how can i view the same . Thanks Naveen ... View more

Hi Team,   We have two routers R1 and R2. R1 is connected to R2 via point to point link. Behind R1 we have a large networks connected with all runnning EIGRP with process 110. The interface on R1 connecting to R2 is under AS110.   Behind R2 wehave large network and all connected to AS 120 and all are running EIGRP.  INterface connecting to R1 is under AS 120.   SO how can we learn all the routes from R1 to R2 and vice versa, as each router belongs to diffrent AS and none of the interfaces were shared to other AS.   Please clarify.   Thanks Naveen ... View more