Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Looking for some (probably basic) network configuration information.I currently have two separate networks (company acquisition)Network 1 is a Novell Open Enterprise (Suse Linux) configured on the 10.10.10.xx subnet with it's own internet connection ...
Currently have a working WAN system that uses an ASA 5505 in my PA office that flows traffic to a WI office over an MPLS line.Traffic flows from Fiber Internet in PA across the MPLS to corp hdquarters and back just fine, however we now need to elimin...
Have a "base" 5505 with the upgrade to 50 inside hosts.I just added the ASA-AC-E-5505 25 Anyconnecr Essentials license key to that unit.The show version now shows Anyconnect Essentials enabled, but the "total VPN Peers" is still at 10.Do I have the ...
I've been reading everything I can find, and I think I understand what is asked of me, but I'm not sure exactly how to do it within ASDMI have used the "wizard" to set up the anyconnect VPN and think that's all fine.But the wizard reminded me that I ...
I have been having a heck of a time trying to configure my 5505 to allow the second segment on my network to use the internet.Office 1 has a fiber internet connection, and all traffic flows fine.Office 2 had gotten it's internet from AT&T, via a netw...
Will check the server configurations today and will be trying to get this finished up over this weekend (boss wants a good report on Monday)The 10.10.10.18 server does have some nat rules while the 10.10.10.9 does notMy next task was going to be to c...
Ok, - I think I'm about 3/4th of the way there. I have a Layer 3 Extreme Summit 400 switch set up with 2 VLansVLan 1 has an IP address of 10.10.10.222 /24Ports 1 through 16 are untagged ports on VLan 1A desktop is plugged into port 1 on the switch an...
Thank You, I think I have it, now I just need to wait until the network traffic is slow enough to implement.In looking at this tho, I do have one final question.Would it be possible to eliminate the L3 switch entirely by configuring eth0/3 on the 55...
Ok, after taking the weekend to clear my head and re think it all, here is what I hope will work. below is a rough drawing of my setup Outside Outside | ...
