Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all. I have wlc AIR-CT2504-K9. After save config and power down, wlc cannot start. In console I see:WLCNG Boot Loader Version 1.0.16 (Built on Feb 28 2011 at 13:14:54 by cisco)Board Revision 0.0 (SN: PSZ163201YR, Type: AIR-CT2504-K9) (P)Verify...
I have Wireless Lan Controller AIR-CT2504 with some APs. When I get any SNMP value from it all is fine:# snmpwalk -v2c -c private wlan-ctl 1.3.6.1.4.1.9.9.521.1.1.1.1.8.4SNMPv2-SMI::enterprises.9.9.521.1.1.1.1.8.4 = STRING: "*********"But when I try ...
I have WLC 2504 controller and six access points AIR-LAP1042N. I reading Cisco 2500 Series Wireless Controller Deployment Guide http://www.cisco.com/en/US/products/ps11630/products_tech_note09186a0080b8450c.shtml and trying to set up along the lines....
I read the Cisco Aironet 1040 Series Access Points Data Sheethttp://www.cisco.com/en/US/prod/collateral/wireless/ps5678/ps11203/data_sheet_c78-609338.htmlIn Powering options recommended for powering• Cisco AP1040 Power Injectors (AIR-PWRINJ4=)AIR-PWR...
There is an example, at the link I gave above, in which ap-manager enabled on four interfaces, which are assigned to four different ports. There are no other interfaces. You want to say that in this case it is impossible to assign WLAN to any of them...
Ok, thanks. I think, AIR-PWRINJ3 will work for me. I have tested my AIR-LAP1042N with D-Link DWL-P200 injector (I had available), its have 100 mb interface and 15W power. He works fine with line about 50 meters. Now I sure AIR-PWRINJ3 will works too.
