Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Having challenge is Discovering the nodes. After multiple reboot of ACI & Leaf I managed to register a directly connected leaf. However it took more than an hour to get IP address. Now registered Spine but discovery in progress for almost an hour.
D...
Hello,We have WLC anchor at main site DMZ zone having an EoIP tunnel with remote site WLC over the WAN network. DHCP server is in the main site which is used by all the remote site WiFi Clients via EoIP tunnel over the WAN.Would the DHCP packets from...
Hello,In an outdoor wifi setup connecting main site to remote sites through point-to-multipoint design, if the main building AP root bridge fails, all the remote sites will be out of network. How shall we achieve redundancy in case of the main site f...
Hello,We have an issue in .css compression on IE6. Hence we excluded .css from compression but still it is being compressed and the page is not getting displayed correctly. In addition I have also applied acceleration policy.Is there any reason why ....
In Nexus 7010Hi Team, In N7010 when i checked the environment status i can see minimum thresold is set to 105 celsius but it documents its mentioned the operation temperature is 0 to 40 celsius. In sh environ temp output i can see the below sensor is...
Thanks Tomas for your response.
Time is in UTC and there is 7 hour difference between controller and leaf. I am able to see APIC in lldp.
(none)# show lldp neighborsCapability codes: (R) Router, (B) Bridge, (T) Telephone, (C) DOCSIS Cable Device ...
As per the below Cisco link which talks about control & data traffic raised the question on the DHCP traffic flow on the control & data traffic?http://www.cisco.com/en/US/docs/wireless/controller/7.4/configuration/guides/consolidated/b_cg74_CONSOLIDA...
Thanks for your response. I would like to QoS only the tunnel control traffic not the data traffic. • UDP 16666 for tunnel control traffic• IP protocol 97 for user data trafficMy question on DHCP traffic, EoIP control or Data traffic?
