Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello.I have configured and tested an ASA-5505 that will be deployed at a customer's home. The ISP cable modem will connect to the E0 (outside) interface of the ASA. All other interfaces on the ASA are configured for the inside network 192.168.5.0/...
Hello all.We are running Cisco Unified CM version 8.6.1 and I am having an issue with getting NTP to work properly. In our enterprise environment, all devices on the network update their clocks to a Catalyst 6513 in our data center running as an NTP...
Hello all.I am trying to determine the best solution for containing a particular multicast within a local LAN. Our network consist of approximately 50 remote sites with three core locations. Currently our multicast configuration involves using ip p...
Hello all.I have recently purchased several 4510R-E chassis switches. After installing all the necessary modules in these chassis, I have a lot of spare blank line cards (C4K-SLOT-CVR-E) that slide into the module guides of the 4500-E chassis. Does...
Hello.I have a WS-C6509 core switch running in hybrid mode (software revisions SP: BTSYNC_cat6000-sup2k8.8-3-6.bin, RP: c6msfc2-dsv-mz.121-27b.E1.bin) that I would like to upgrade to native mode IOS revision c6sup22-dsv-mz.121-27b.E4.bin. The core ...
The only caveat I see with that setup is automatically determining devices that are authorized to connect through the VPN tunnel vs unauthorized devices that aren't supposed to connect through the tunnel. I would need to set static IPs on devices ...
I'll have to try that on my core switches.I've been having a similar issue in which contractors were replacing HVAC controllers at many of my sites with newer models. They used the same IP addresses on them and had the same problem...they couldn't e...
If we need selective mcast traffic at the Local LAN among different VLANs and selective mcast traffic to cross the WAN using Anycast RP then I would suggest we can go for a local RP at each such remote site and run MSDP between the across the WAN RPs...
So as I understand by reading the above requirement we want to ahve here Multicast within the Local LAN at each remote site and only selected multicast traffic needs to cross-over the WAN. Is that correct ?That is correct.Below is a very helpful docu...
Can you please explain in more detail what do you mean by ---Containing Multicast Streams with the Local LAN I want to be able to contain one of our multicast streams within the local LAN at each remote location. I tried using a multicast IP of 239.1...
