Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Trying to get https://mail.abc.com redirect to --> https://mail.abc.com/xxxI've got the configuration working for: http://mail.abc.com --> https://mail.abc.com/xxx
I have 3 virtual servers sharing the same IP, just using different ports.192.168.1.1:8000 = server1192.168.1.1:8001 = server2192.168.1.1:8002 = server3I would like to loadbalance across all 3 with the following probe, looking for the URL.http://192.1...
I would like to configure this appliance to use ACS authentication. Right now I use local authentication, but would prefer ACS instead. Both the WebUI and the console are using this local method and I would much prefer it to use ACS instead.I get t...
Not sure what this error message means.This is my configuration in brief:Model: N5K5596 using Fabric PathSoftware: version 5.1(3)N2(1)interface port-channel101 description xxxxxxxxxxxx switchport switchport mode fabricpath lacp min-links 2 sw...
I've seen a lot of examples of how to do this, but either they don't make sense to me or there's something I'm missing within the understanding. Hence I'm posting my question here. (my apologies for the repitition in advance).There is currently con...
Found my problem...I failed to put in the "port" statement under the probe.After doing this and then verifying the RSERVER status, all the probes now show as OPERATIONAL.!probe http WEB1-http-probe port 8000!
Update... root@HOSTNAME.localdomain# ip http tacacs+ enable Secret key: Repeat secret key: Successfully enabled Tacacs+The problem, I'm faced with now is that after entering the above the WebUI is still not accessible.
Answered...Removed the configuration for Po101Configured all applicable ports which will participate with Po101Re-Configured Po101 with the original config.interface port-channel101 description xxxxxxxxxxxx switchport switchport mode fabricpath l...
Thanks for the response.Any idea or reason why this feature is not enabled by default?If this is a true enhancement I'm curious as to why one should have to manually enable it.
I'm curious to know if the command 'sysopt np completion-unit' was enabled on the FWSM in a single firewall mode or if there were multiple contexts on the FWSM?Have you found any issues since running the above command? Are you aware of any bugs rela...
