Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
long and short - I have a cable modem service that offers a single dynamic IP address for public access.
I would LOVE to setup a VPN style connection so I can get into my network while I am traveling if I ever needed to.
I have spent much "quality"...
Hey all. I don't post much as I generally figure things out with reading, GNS3, and labs. I however got to a point that I can't seem to figure an engineering task out due to my lack of experience.
Below is a rough diagram of a network I am using to...
I'm going to present this as laymen as possible in hopes the understanding doesn't get convoluted. This question is based off my previous link, which I can't see to get to work. https://supportforums.cisco.com/discussion/12419431/asa-5505-nat-and-a...
I feel as though I've tried many options to get NATing and my ACLs to work correctly to provide external access to my internal security cam.I've included a layout of my network in hopes it can help.My internal to external is working fine and I can ro...
I am feeling frustrated and yet, I feel lame... I am trying to setup a general access list allowance on my asa. I would like to set a permit via the gui for now where source = anyport allowed is tcp/udp 15488 As for the destination, do I set it to ...
I get it -- this post is OOOOOOLD.... I'm just posting a link that appears to address this process of what you do if you end up getting the BIST Init error. For me, I substituted the bin file for v16 https://community.cisco.com/t5/switching/downgrad...
Hey Flavio. Sorry for the delay -- to answer your question about the modem -- no, I'm not wanting to establish a VPN connection with the modem.
I have an Aruba RAP that I'd like to setup for testing purposes. I deal with the RAP on an enterpris...
--> chrihussey: You are correct. it doesn't appear to work. I've tried so many options too, I can't remember if I even saw join requests coming from a receiver off the same subnet from a packet capture. as for adding sparse-mode to the lo, I had ...
Hey Jon. I appreciate the assist on this. the end goal is to ensure this is working as I have a non-Cisco wireless controller connected via port channel. One of the issues I've run into with this, is the fact that if I am wired I still can't strea...
