Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, Suppose I had the following configuration in an IOS router interface <interface type/number> ip address 1.1.1.3 255.255.255.0 secondary ip address 1.1.1.2 255.255.255.0 ip route 0.0.0.0 0.0.0.0 1.1.1.1 access-list standard INTERNET_BOUND_ACL p...
Hello,I have a Catalyst 3650 operating as a Mobility Controller. I had to change the interfaces on the 3650 that connected to the access points to explicit access ports (switchport mode access). Before that command was configured, the APs sparatica...
We have two buildings 300 feet apart with perfect line of sight. Price aside, what is the best point-to-point wireless bridge avalable from Cisco at this time? 54 Mbps max with 802.11a on a 1400 series wireless bridge is nowhere near acceptable for ...
Stephen,Is there an alternative to the 3650/3850 series switches I can use as a Mobility Agent? As I am only needing to terminate 2 CAPWAP tunnels, can I use something like a 2504 as a Mobility Agent? If not, is there another series that is less ex...
Stephen,Thanks for the quick reply. Unfortunately, the 3650 is the only WLC in the building, which spans well over 300 feet in either direction to the APs. We positioned the 3650 to where we are only leaving a few APs not directly connected as they...
I have been on vacation and my team just rolled back to DMVPN. I am going to have a similar project within a month or so, and will try the exact same settings to see if this fixes it and let you know.Thanks again!
We've been working with these confs for a while, so they aren't as clean as they could be, but here they are----------------HUB----------------version 15.2service tcp-keepalives-inservice tcp-keepalives-outservice timestamps debug datetime msecservic...
