Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Thanks all for your responses.I have yet to sucessfully convert my 1552E to autonomous mode for my site surveys.I am attaching the IOS Bootloader image from latest attempt.The AP is not attached to a controller. it is directly connected to my laptop ...
Hello,Just a quick question to verify that the maximum number of WLCs a single WCS can support is 50.What one do if you had 55 individual WLCs in seperate buildings you wanted to manage throughtout a School Division for example?We are also looking at...
I was wondering if anyone would happen to know what thelow, medium, high power settings are on the AP541N in either dBm or mW?The data sheet indicates what the maximum/full power settings for 2.4 GHz are:802.11b 15 dBm802.11g 15dBm802.11n/20 MHz 12 d...
I was wondering if anyone knows what the low, medium and high power settings on the AP541N in dBm are.The data sheet indicates what the maximum /Full power setting are:Available transmit power settings (maximum power setting will vary by channel and ...
I am trying to locate Cisco's recommendations of Best Practices on deploying (1300 Series) wireless briding and VoIP and Wireless VoIP. I have found in some SpectraLink literature that indicates that,"SpectraLink does not support a configuration that...
If you have a valid Cisco CCO account you should go to:
https://rftool.cisco.com
Once you complete the questions and draw out your walls you can get a good budgetary/predictive output for your project. Remember that this is strictly a predictive outp...
The only way I was able to convert the 1552E to autonomous mode was adding the MAP to my 2504 lab controller and then with a laptop connected to the network download the code via tffp. It loaded the new file within 5 minutes. No where does it state ...
Thanks to Vic Nunes for posting the Cisco Aironet 1600/2600/3600 Series Access Point Deployment Guide, I have used the ant2566p4w-r antenna with the 1602 access point and it works great. The documentation link is below.https://communities.cisco.com/...
