Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,Is it possible to use IVRF/VRF setup without VTI? Having hard luck getting it working and not finding many examples on Cisco page.Did manage to get VTI version working, but not every device supports VTI so need old fashioned direct encap....
Hi,We are having problems connecting our Nexus 2k to HP server ports in LACP mode (channel-group mode active).The below is snippet from logs, before the port goes into suspended mode.2013 Jun 7 17:14:21 PBR-core-1-PoC %LACP-FEX104-3-SYN_COLL_DIS_EN:...
I'm curious how to build PVC through BPX to 8850 MGX via CLI. Specifically, how the channel and port relationship works between the MGX and BPX on a frame-frame service.Say we have circuitMGX-BPX-(atm_cloud)-BPX-MGXusing FRSM cards on MGX 8850 both s...
Hi Marcin,Thanks for your help so far.R2# debug crypto isa and debug crypto ipsec shows nothing.R2# debug ip packet shows packets coming from R1.Seems nothing is triggering ISAKMP on R2, the packets I see are sourced from Eth0/0 on R1, destined to Et...
Thanks Steve, I did see that error message, however didn't understand the full implications. You have given me some good leads to follow. Will try some different drivers.Cheers,
Thanks Steve,Yes, the server teaming is set to Dynamic. We systematically tried every single combination, the only one which works is static LAG (channel-group mode on for Cisco, switch-load balancing for HP).Cheers,
