Suppose Site 4 has a service device (firewall, etc.) to share, and it advertises it as netsvc1 for service insertion. The edge router at this site receives a packet marked for this service. How does this edge device direct the packet to the service d...
In SD-WAN service chaining, using custom topology policy, does the fw keyword really do anything different than netsvc1, netsvc2, etc.? The firewall is presumably an external, possibly third-party, device, not configured by SD-WAN, correct? And SD-WA...
In the SD-WAN documentation, it says "To change the BFD session modes between software mode and hardware mode, you need to remove all existing BFD configuration and reconfigure it." This seems to be the only mention in the documentation of these mode...
When entering the command "show control-plane host open-ports" on a router, with web services running and no current connections, the command output shows two entries for Port 80, and two entries for Port 443. Why two of each? Does this mean the rout...
I reserved a Meraki sandbox, and have logged in, and the network assigned to me has no MX or MS devices, only two MRs.
Also, when typing on this page there is a section called "Labels" on the right. It is always prefilled with the label "DevNet Sand...
That's interesting. When I was connected, the DNAC and ISE were both unavailable via HTTP, and also neither was replying to pings. Those are the two devices I specifically remember trying.
Well, it's been over two hours since that second email, and it's still not accessible. The DNAC itself is definitely one of the devices that is supposed to be available. There's even a link in the instructions to HTTP to it, and that also fails. I ch...
