Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
A client has asked me to configure PAT on their PIX to forward 3389, 80, 443, and lotusnotes ports to an internal IP. I have done this same configuration on other boxes approx 150 times with no issues but for some reason this one is killing me. Can...
Is there any way to recover an enable mode password for a CUE module? I can access the module through a 'service-module service-engine1/0 session' command, but when I try to enter enable mode it becomes apparent that the previous administrator of th...
A client of ours requires access to the Callmanager Express web GUI but after entering the administrator password in the web login prompt I receive the following message:"Cisco Unity Express has lost contact with the Host router. Enter the new CCME W...
Our issue is a bit complicated. We are implementing a ShoreTel VoIP phone system which supports VLAN tagging to separate Voice and Data traffic. At this location, we have a Cisco Router (currently obtaining model #) which is connected through a new...
I am having an issue with a flapping backbone link as detailed in the log below:Aug 3 14:38:30: %C4K_L2MAN-6-INVALIDSOURCEADDRESSPACKET: (Suppressed 749 times)Packet received with invalid source MAC address (45:42:55:47:3D:57) on port Gi4/2 in vlan ...
Why would this be expected behavior? What happens when multiple organizations are managed by a single entity like an MSSP? The MSSP has to go into every organization and disable/reenable their SSO instance for every client whenever an employee is r...
Rob,Thanks very much for the quick reply!These are actually the two documents I found and tried in order to remedy the problem. Unfortunately after following the procedures outlined in both the results didn't change and I'm still stuck. I am schedu...
You need to manually add an ARP entry to the L3 pointing at the virtualized MAC of the NLB. Because it is using a multicast MAC for the NLB the L3 device will not cache the Unicast IP associated with that MAC and therefore can't route any traffic pr...
Unfortunately I already tried sourcing that address to a port on the Dell switch and I haven't been able to see this MAC listed. Also, I have throttled logging up on the Dell to hopefully get some more insight but it does not appear that they run th...
