Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, We have ASA running 9.1 and using Anyconnect VPN. We have internal DNS servers configured in VPN profile and that works fine for nslookup resolutionIf i try using 8.8.8.8 or any other public DNS servers or DNS server of other Datacenter, it is no...
Hi,My requirement is to assign 2 different public ip address on ASA outside interface..This is required as i want to form ipsec site2site vpn to this ASA using 2 different ip address from remote end ASA.Is it possible to assign 2 IP in this way to fo...
Hi,Is there any issue in writing logs to the router flash. Is there any possibility of getting the flash corrupted due to continious writing of logs to flash.ThanksRaj
Hi,Need to confirm on this. Can we use same IP pool for two different Client VPN profile on ASA.There should not be any IP conflict if users connects using both profile.ThanksR
Hi,I have enabled syslog setting on my ASA 7.2 logging enablelogging trap alertslogging host inside x.x.x.x tcp/1468logging facility 20Whenever i enter logging facility 20 my syslog server starts receiving logs but stops after 15-20 min.Also logging ...
both those commands are already in place and i am able to ping those DNS servers. Only DNS resolution doesnt happen using those public DNS serverShall i enable DNS inspect?
Ok, this is what i am getting in pakcet tracer Phase: 1Type: ACCESS-LISTSubtype:Result: ALLOWConfig:Implicit RuleAdditional Information:MAC Access listPhase: 2Type: ROUTE-LOOKUPSubtype: inputResult: ALLOWConfig:Additional Information:in 0.0.0.0 ...