Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm not sure what the deal is, but I just cannot get port forwarding to work. I've never had an issue before in 8.4 (after going to 9.x I've downgraded thinking that was it). I've followed the steps noted here: https://supportforums.cisco.com/threa...
I'm about as green as you can get when it comes to EEM so I'm wondering if the following is possible w/out using IPSLA (our 65's don't support it).Basically what I'm looking for is a way to do the following:1. Track a downstream, internal IP.2. If ...
I had started this conversation in the "General" area (I think incorrectly) so I'm going to post it in here as well (just in case - appologies to the moderators).In our aaa implementation we use tacacs with the local db as backup. Well, I'm trying to...
In our aaa implementation we use tacacs with the local db as backup. Well, I'm trying to harden security. I know IOS has this nice little command:“login on-failure log every xâ€This would be great so we could at least see the syslog message and ha...
This is the first I've seen of this problem, but even after building the NAT with the interface rather than an IP I still am getting constant TCP discards...
Great suggestions, thanks. Unfortunately, the device is behind an SVI so I don't have an interface I could track otherwise it would work.And unfortunately Mr. Clarke we completely lack the ip sla command. Either way, the traffic this currently pert...
