Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to check interface receive/send counters using snmp. my polling interval is once per second (just couple of ports) since I suspect my network traffic has quite a lot of microbursts which are not detectable by my other network monitoring ...
I am doing ftp application inspection on a traffic that matches ACL ( permit statement) src dst host.This part works fine.However, I want to exclude group of hosts from being inspected by my own policy and I want them to use aglobal one. I am acc...
My router R3 is connected to 2 other routers, R1 and R2. Each of them is sending me one multicast group that I can subscribe to.They are all running PIM-DM.what I have noticed is that, multicast traffic that is received from R1 is being also pushed b...
I would like to connect remote office user to our PBX system over VPN connection.I was looking into 2800 series routers to do that, but I am not sure what kind of card will I need for that. Can I connect our digital pbx phone directly to the router-s...
i have used multicast ttl-threshold command to stop traffic from going out on unwanted PIM-DM enabled interfaces.I removed the text of my message about multicast boundary because it initialy did not work. (my fault. I had incorrect ACL)I just confirm...
