Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 2950 switch which has a bad image in it and wanted to know if tftpdnld is supported on these platforms or do i have to go with X-modem.Please suggest.
On the supervisor desktop, some agent names and the login names are missing. Checked the skills assigned per analyst.ICM 7.0 SR3-CTIOS Server 7.0 SR2-CCM 4.1.3. Please assist.
Upendra,You can use c1841-ipbasek9-mz.12.4-15.T5 but still i believe your IOS should support NBAR. Use this tool to choose the right software for your site based on requirements.http://tools.cisco.com/Support/Fusion/FusionHome.doHope this helps,Ratis...
Hello Vikas,You would have to download the IOS again from a good source (preferably Cisco) and try again. You can also verify the checksum with the following command :Router#verify /md5 'Put the correct checksum here' flash: c2600-i-mz.123-22a.binHop...
Hello Rafael,The Cisco 2821 chassis comes with the power supply included. Not sure if you would get the same part number mentioned above. Looks like that part would fit in for a 2821 and 2851. Hope this helpsRatish
I tested with some more configurations and here is what i got:Any new switch(VTP-SERVER/VTP CLIENT) added to the existing network with null domain and higher config# would get updated with the existing domain name and it would change to the existing ...
Answer is no. But the newly introduced switch would be updated with domain name 'cisco' and its config reg# would become 3 if the new switch is vtp client. And if it is a vtp server then nothing would change.Hope this helps.Ratish
