Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear,
My apologize before, I have a case in my customer network.
This is the network condition :
all branches are connectde 2 Backhaul.at DC and DR, we have three condition for branches.
which are some of branches using Dynamic (BGP) , some of branc...
Dear , I have requirement to deploy WAN Network with enterprise license, with below detail :Bandwidth > 512 kbps : 500-1000 TCP ConnectionBandwidth 256 – 512 kbps : 200 – 500 TCP ConnectionI see the matched router is C2951-WAAS-SEC/K9, but from Cisco...
Hy Guys,I want to ask something about compatibility of Remote control in MXP 1700 for Ex90.could be use TRC4 remote on EX 90 ? because i've got hardware replacement for MXP1700 with EX90 , but there is no remote touch screen for EX pack.Thanks&Gbu,B...
Dear SirI need advice and suggest about my configuration between Gatekeeper and Bordercontroller.i have a problem in zone status . i have notice that "No Gatekeeper reachable" in Gatekeeper and "No active client" in Border Controller.i attach some ca...
Dear Sir,I wanna asking about SNMP on Tandberg Device, what information that i've got when i using that ?my Vicon Infrastucture will be include to Monitoring system.So my Customer need to know about all of information from Tandberg Device SNMP, what ...
Hy Sir,Thanks for all suggestion.My EX is can be use now with TRC4 remote.but, there is something issue on here.when i boot or restart this ex, the latest configuration back to the default.especially on SystemUnit Experimental MenuType "Full" , back ...
Dear Mr MartinYes got it Anyway, the type of remote for 1700 is trc4 right ? In this condition,i just maintain edge and mxp series for my customer, and currently just only one ex90 type.So, If trc4 does not work for ex90, it means i cannot operat...
Hi,Dear Danny and Martinthankyou so much about ur suggestion.i will try to connect with telnet for my EX tomorrow. i has not tried last day because any vicon event in my customer.Yup mr Martin,this is replacement of my MXP1700 broken device. I heard ...
Dear Mr DannyI was tried to activate remote TRC4 from my MXP for EX90,i run command that you suggest in my Ex90 like below.xConfiguration Experimental SystemUnit MenuType: FullxConfiguration SystemUnit IrSensor:Onbut when i try to console with hype...
