Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Folks,I have issues understanding the EIGRP update process. Attached is a word document containing screen shots from a Wireshark capture. Please, have a look at them and offer your thought. Thanks.
Here I have an excerpt from a Cisco documentation:The following example shows how to configure two Ethernet interfaces to obtain the next-hop router IP address from the DHCP server:ip route 10.10.10.0 255.255.255.0 dhcp 200ip route 10.10.20.1 255.255...
Greetings All,Please, recommend how I can configure secondary IP address pool in a Cisco IOS DHCP server. The screen shot below shows the syntax error I am getting even though I am following Cisco's documentation. I thought the failed command above ...
Hello People,I am studying EIGRP configurations and verifications and I come accross a sub topic on EIGRP Over MPLS. I take this to mean that I need to understand the rudiments of MPLS in order to be able to configure EIGRP over it. However, I do n...
Hello All.I am reading the following book and trying to practice with the topics.Implementing Cisco IP Routing (ROUTE) Foundation Learning GuideFoundation learning for the ROUTE 642-902 ExamDiane TeareOn page 34 of the book, under the heading "The IP...
Thanks once again. My confusion lies in the fact that 209.165.200.255 255.255.255.255 specifies an IP address rather than a network address. Does it not matter?
Thanks a lot Mr. Nawaz. I need one more confirmation. Is the IP address 209.165.200.255 the address of the exit interface or is it the address of an interface on a remote router?
Apology for resurrecting this thread. I will very much appreciate it if the commandRouter(config)# ip route 209.165.200.225 255.255.255.255 dhcpcan be explained in a way that a newbie can understand. I thought a static route command needs to specif...
