Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have two offices, one in Ohio and one in Wisconsin. The office in Wisconsin connects back to Ohio over site to site VPN for Internet. Client is wanting to connect a new Cisco AP out in Wisconsin and configure AP and switches for Guest VLAN. Curren...
I have a test environement I am working on for some future needs. Attached is the config on the ASA5520 that I am working with. I need to be able to be plugged into the 10.14.101.0 network and communicate with the 10.14.105.0 and 10.14.107.0 networ...
Client has a block of 5 static IP's for the ISP. They currently have them all in use and set up with static nat (Inside,outside) commands. They are adding a new web application and ftp server that will need to be accessed from the outside. Is it p...
Have not worked with this router before, so I am not familiar with it at all. I have a client though who has requested some help on a routing issue. They have two networks connected via this router and they cannot talk to one another. From the des...
Have multiple Catalyst 2960S switches, Cisco 2911 router and ASA 5510 firewall.On the router have subinterfaces created for the VLAN'sInt FA0.0/41 for wirless VLAN setup with IP 10.10.41.100Int FA0.0/60 for new Voice VLAN setup with IP 10.10.60.100In...
So let's say that I have a public IP 50.50.50.50 that is already in a static nat command to internal 192.168.1.2 and access list setup to allow pop, http, https, and smtp to this server.I cannot setup the above and tell it to use the same 50.50.50.5...
