Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I am struggling to get our 887VA setup for our config.We have a public IP range from our ISP and we have multiple servers behind our router. One of the servers need large ranges of ports open so I have ended up trying to use a ‘rotary’ nat poo...
Hi All,I have got it working by using a route-map.I am not 100% sure about all this......anyone want to comment on the suitability of my config?!ip dns serverip nat inside source list 1 interface Dialer0 overloadip nat inside source static 192.168.22...
Hi Bongsu,All the 9971 phones register ok and work fine but after a while some will not take incoming "internal" calls from other extensions.If we delete the phone and re-add it in CCA it then works but may stop receiving after some time. Simply rebo...
Hi Jose,We have flashed our 8941 with the Sip firmware and set it up in CCA as 9971 (as it is not officially supported) and is working fine for video calls. We also have 9971 and both can call each other.I hope this helps.Let me know if you need help...
Hi,Thanks for the reply, we have tried your second fix and whilst it has stopped them rebooting some of them do seem to drop their incoming extension.E.g the phones can dial out but will not accept incoming calls.Any ideas on this?Best regards,TimSen...
