Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I am having a tough go at prioritizing multicast traffic on our office 3750 switches. We have a single 3750 connected to our main fiber ring switch which is marking all multicast traffic on our primary IPTV vlan (500) with a cos value of 5. On...
Hello,I have two ospf processes running on a single 3570 edge router that has a dedicated transport circuit back to our network core. We are adding an additional "transport" only circuit into a new location that is also apart of the second ospf proce...
Hello,Is it possible to bridge two interfaces together and run OSPF between on each interface? Example: We have a remote site with two connections to a central location. We would like to share the bandwidth of both connections between the two locatio...
Hello,I am trying to prepend out routes using one of my upstream providers. I was told by the ISP that I needed to do this using a set community command. In order to prepend routes to this ISP i was instructed to use as example 1234:XXX (where 1234:2...
Hello,
Thank you for the response. To answer your question, the multicast traffic is coming in over a trunk interface on the 3750. Some receivers are directly connected to this same 3750 on access ports but there are at least two other 3750's conne...
Our backbone area 0 is getting pretty big from a number of routers standpoint and a number of route standpoint. Please we need to do inter-area summarization within each area 0 process.
Is this just a "Cisco" thing? Because I can do this using a MikroTik, StarOS, or ImageStream routers. Our site to site links are wireless backhauls.Here is an example:Site A:Int1description Link A10.1.0.1/30opsf point-to-pointbridge1Int2description L...
lol. I agree.What I have is two 30mb links. If we bridge the two interfaces, we affectively get close to 60mb aggregate. At this central locations we are also running other instances of osfp on our backbone network.All I am asking is if this is possi...
