Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
It's my first time of upgrading the UCS firmware, and I've read many documentations, videos, release notes, and I would like to know if there's any gotchas that I should watch out for. I am planning to perform the firmware upgrade in the next coupl...
It's my first time of upgrading the UCS firmware, and I've read many documentations, videos, release notes, and I would like to know if there's any gotchas that I should watch out for. I am planning to perform the firmware upgrade in the next coupl...
At both the remote site, I've a Cisco 2811 connected to two different MPLS providers..say ProviderA and ProviderB running BGP using the same AS number. The same is at the core 7206, but ProviderA has a "weight" assigned as 55555. When I assign the ...
I've setup a test environment using GNS3 with 2 Cisco 2691 routers (same IOS)connected to the generic L2 switch.Router_A = Primary Router_B = BackupResults: - Router_A becomes the Active router just fine after it's first configured for HSRP - When Ro...
Is there a simple way to really verify that the cisco 3560 is a layer 2 or layer 3 switch? or is it actually dependent upon the ios image that it's running?Switch model number is WS-C3560-48PS-SThanks.
I see your internal networks are on .1x and 2x subnets.
Try adding "route inside 192.168.0.0 255.255.0.0 Gateway" to see if that works. If that does not not work, pls. post your router and switch configs.
Do you have internal subnets 192.168.3.x, 192.168.5.x, 192.168.15.x? If you do, your VPN IP ranges are in conflict with the internal networks. Try reducing the range and ensure that you've proper routing in place for those subnets.
Hi Jayatu,
I've completed the firmware upgrade to 2.2(6e) successfully a couple of weeks ago.
The "autoinstall" of the Infrastructure went smoothly, but the autoinstall for the server blades did not complete successfully for a few blades, so the fi...
