Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day, Need a little assistance.I need IP 192.168.1.1 to be nat’d to 100.1.1.2 for internet access when the destination is NOT 10.10.10.0/24(tunnel destination). Egress interface is the same. Can anyone provide an example of this? much appreciated...
Hello all,I'm having a problem with NAC 4.6.1 and agent 4.6.2.113. If a client already has an older CAA installed they get prompted to upgrade and it works fine. However, if no agent is installed and you try to install it from the http page, it acts ...
Here is an example from another message on this forum: I assume this is what I would need, correct? Thanks all! Re: Static NAT with exclusionaccess-list 101 deny ip host 192.168.100.6 192.168.200.0 0.0.0.255access-list 101 permit ip host 192.168.100....
I have this problem as well. In fact, it doesn't work when using radius-NAC either. We are trying to perform posture remediation using ISE for MS Updates in our posture redirect ACL using URL-Based ACE's, have engaged countless TAC engineers to no av...
That was one of the first things I checked. This really stinks because we are having to install the agent manually.I found other blogs where people are having the same issue and none have corrected it yet.I can call TAC but from past experience, well...
