Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have an N9K that we use a loopback interface on for monitoring tools. A number of these tools use SNMP to poll this loopback IP address. At times, the SNMP GET RESPONSE will take more than 5 minutes to show up (typical average is around 2 second...
This is probably a dumb question but I need to ask as my cellular WAN expertise is minimal. I support a few cellular WAN sites that have the 881G+7-K9 router that connects to a provider 3G network. The router is end of life and the location now has L...
Hi!I am trying to find out how to determine the tail drops on a host interface of a 2232pp fex. When you run the following commands:attach fex xxxfex-xxx# show platform software woodside intsyou get output like:...| SS0 : ssx_int_norm_td ||--+-------...
Something that would really be useful is a way to see what SFP is currently in a 1552H mesh node. These nodes are up on masts and can only be accessed through much approval. On a switch when you do a show int status it will actually tell you what typ...
Thank you for the reply. I decided to check the install guides and found the C1111 models have dual micro-SIM slots. The specs for 880/890G mentions dual mini-SIM slots. So it looks like I would need to order a micro-SIM with new cell number for the ...
Thank you for the reply! When I run the show platform software woo new_ints command (after attach fex xxx), the output does show stats for SS4, SS5, SS6, and SS7. Are those names used to differentiate between the use of SS0, SS1, SS2, and SS3 for the...
Hi, did you ever get this resolved? I have a 6509-E that I get the same message on at reload time. Cisco had me replace the SUP720 but that didn't fix it. I also removed the compact flash card and did a reload. Still got the message.
