Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Background Information:* WLC: 2504 running on 7.4.100.0* AP: 3600 and 1140 with FlexConnect mode* Switch: Avaya POE GB switch * End Point OS: Win 7 x64 Enterprise* End Point Hardware: Mainly Dell Latitude E series with Broadcom adapterI ran in...
Hi, I'm new to Cisco Wifi infrastructure and don't have much experience.Recently we have deployed 1 x 2504 WLC with 14 x 3600 APs, all the access points are configured as Flexconnect mode.Generally, the Wifi is running well, but we had a few clients ...
Hi Scott,Please see below for my security settings:* Layer 2 Security: WPA+WPA2 with AES encryption* AAA ServersWhen I look at clients under monitor tab, I can see those clients are connected as 802.11bn. Can you please advise?Thanks,Yan
Hi Rasika,Thank you so much for your advise. On 802.11a/n, I set the channel width as 40MHz, any clients with dual-band adapter now connected as 300Mbps which is excellent. As per Scott's advise, I disabled 11mbps data rate and all lower ones. Any si...
Hi Saurav,Does it mean I have to go to each access point and configure the radio setting, the link you sent me is for AP, not WLC...Can you please advise?Thanks,Yan
