Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Introduction=============Many people have run into an unfortunate error while installing Windows 2K8 R2 onto C-series hardware. While it looks like everything is working correctly, when the server restarts an error appears:The computer restarted une...
Tony,Check out this utility:Nexus 1000V and ESX Upgrade UtilityYou put in the version of the n1k and ESXi that you are upgrading to and from and it prints out the steps.In this case you need to update to at least SV2(2.1) for ESXi 5.5 support. The c...
Rob,It's even easier then that - all you need to do is deploy a new VSM with the Primary role. When this new VSM comes up it will broadcast out the control VLAN looking for other VSMs. It will see the Secondary Active VSM with the same domain ID an...
You can redirect the output from any NXOS command to a file by using the following syntax:command > file_nameYou can then copy the file off to a FTP/TFTP/SCP server. The no-more works as well, but this is a handy trick.
There is many things that can cause the health:inoperable. The most common times we'll see this is the following:1) A DIMM is failing in the server. Normally this would produce another fault, but sometimes you need to check the SEL log to see what ...
Unfortunatly there isn't really one - with direct attach storage there is still the requirement that an upstream MDS/N5k pushes the zoning to it. Without a MDS to push the zoning the system it's recommended for production.http://www.cisco.com/en/US/...
