Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, We've got an application which has been working on several CUCM installations and versions.With this particular 11.5 CUCM server we're always getting a PlatformExceptionImpl with message shown in subject.Call goes through and external phone r...
Hi ALL,
I an UC540 have a dial-peer defined like this:
dial-peer voice 1500 voip
description ** Outgoing CallBrokerCC SIP gateway **
destination-pattern [*]?3..$
session protocol sipv2
session target ipv4:192.168.x.x
voice-class codec 1
voi...
Hi All,Just comming back to report. This was the phones speed dial feature preventing dialed digits to be actually sent over. Customer didn't use speed dial but didn't want it disabled.Finally got my provider to modify its product to take postfix ast...
I'm a bit out of my water here but I'd say when * is dialed nothing is being actually sent to the DP selection code. Then, when the inter-digit timeout hits the call gets disconnected and I get a busy tone.Could it be Feature Access Code which is int...
OK, I'm back with promised logs.
As far as I cant tell, the phone is not actually sending any digits when dialing starts with "*", This is an SPA-301 phone. Does that make any sense?
The intent of this destination-pattern is to match any 3 digit numb...
Many thanks for your answer.
This is on a remote client location and I won't be able to get anyone to check untill 02/01. In the meantime what output be suitable? Maybe
debug voip ccapi inout
debug ccsip messages
I'll come back with output for the...
