Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there a recommended way to dual uplink a meraki MX in one armed mode that doesn't involve a warm spare or L3 between the MX and the stack?Topology:MX68 -> Cisco 5500 Stack -> Cisco FTD2130 pair - ISPsI'd like to be able to connect each of the mx68...
We are testing the Meraki MX68s to replace our aging remote ASA FWs and ISR2 routers. We have about 2 dozen remote sites that current have a L2L VPN to a FTD pair at our DC.How do people configure the Organization-wide settings on the Meraki Dashboa...
Is it possible to set some of our remote users jabber to bypass our expressway servers and connect directly to our CUCM and CUP servers like they were onprem? Our remote works all have vpn connections that could be used to connect jabber to CUCM. We ...
I have two ASR routers that handle my internet traffic. Each has one ISP (Comcast and Lumen). For some reason, the router I have connected to Lumen is adding a metric of 7800000 to all the routes it learns from Lumen. I have a fairly straight forward...
This may not be possible, but here's hoping. My VMware environment is 100% Cisco UCS B servers. I had an incident recently where our ESXi host servers became disconnected from our vCenter Server. Now per VMware support we need to shutdown the guest V...
I found my answer. In short, not possible without the warm spare.https://community.meraki.com/t5/Security-SD-WAN/Nexus-VPC-with-Meraki-MX100-One-Armed-Concentrators/m-p/95374#M23925Meraki: please add some kind of link aggregation to your devices.
Hi Jamie and Roger- I built a new vpn group today that does not use split tunnelling. When I connect that vpn and try to log into jabber I get a "Cannot communicate with the server." When I look at my firewall logs it looks like Jabber is still tryin...
Hi Giuseppe-Thanks for the reply. That is what I suspected, but Lumen said they were not setting the MED. The two ISPs do not have an agreement between them. Is their anyway I can prove to tech support at lumen that they are setting the MED?Thanks
could you explain "check the IGP in router originate it and find the cost of this route" a little more? The example I posted came from the router that has the high metric. My other ASR doesn't do the same thing. It always shows it's metrics at 0.
Hi BB- The FIC is the layer 2 device and I was looking for the command to get the MAC address table out of the FICs. I found it by connecting to the local-mgmt of the FIC and then I could run a show mac-address-table.
